Case 580N, 580SN WT, 580SN, 590SN Tire 4B (Final) Tractor Loader Service & Repair Manual 48080071 PDF

Pages: 451
SIze: 3.66 MB
Configuration: PDF
Language Type: English
Accessible: Every Time
You Can Download Instantly After Purchase
Remarkable Assistance: 24×7
Provides High Quality Illustration Diagrams With Clear And Concise Explanations
Cooperative With All Versions Of Windows, Mac, IOS, Android.

This PDF manual provides comprehensive service and repair information for your Case 580N, 580SN WT, 580SN, 590SN Tire 4B (Final) Tractor Loader. Detailed instructions, accompanied by hundreds of high-quality photos and illustrations, will help you maintain your machine in peak condition. With this manual, you can troubleshoot, repair, and maintain your machine to keep it running smoothly for years to come. This PDF manual is a one-stop shop for all of your service and repair needs for your Case 580N, 580SN WT, 580SN, and 590SN Tire 4B (Final) Tractor Loader. With step-by-step instructions and detailed illustrations, this comprehensive manual will help keep your machine running smoothly and efficiently for years to come.

Models Covered:
Case 580N, 580SN WT, 580SN, 590SN Tire 4B (Final) Tractor Loader
580N PIN NGC730186 and above;
580SN WT PIN NGC735098 and above;
580SN PIN NGC732639 and above;
590SN PIN NGC736228 and above;

Table Of Contents:
1001-Engine Air Filter Blocked
1002-Coolant Temperature Above Normal
1003-Air conditioning pressure too high
1004-Hydraulic Filter Blockage Detected
1005-Power shuttle over speed detected (*)
1009-Transmission Oil Temperature Is Too High
1010-Foot Throttle Sensor Signal Not Plausible
1011-Foot Throttle Sensor Signal Above Range
1012-Foot Throttle Sensor Signal Below Range
1013-Foot throttle signal out of range, signal unusable
1014-VCM Battery Voltage Is Too High
1015-VCM Battery Voltage Is Too Low
1018-Boost Air Temperature Is Above Operating Temperature
1019-Engine Coolant Is Above Operating Temperature
1020-Transmission Oil Is Above Operating Temperature.
1021-Fuel Is Above Operating Temperature
1022-Water In Fuel Detected
1023-Foot throttle supply voltage out of tolerance high
1024-Foot throttle supply voltage out of tolerance low
1025-Foot throttle supply off scale high.
1026-Foot throttle supply faulted low
1029-Foot throttle sensor off scale high
1030-Foot throttle input low.
1031-Hand throttle supply voltage out of tolerance high
1032-Hand throttle supply voltage out of tolerance low
1033-Hand throttle supply off scale high....
1034-Hand throttle supply faulted low
1035-Hand throttle sensor signal above range
1036-Hand throttle sensor signal below range
1037-Hand throttle signal out of range, signal unusable
3090-Camshaft speed sensor values are not plausible
3091-Camshaft speed sensor pattern is not plausible
3093-Compared camshaft and crankshaft speed sensor values are not plausible
3096-CAN A Bus off failure
3097-CAN B Bus off failure
3102-Fuel rail pressure sensor voltage is lower than expected
3104-Fuel pressure relief valve is open
3105-Fuel pressure relief valve is forced to open, perform pressure increase 3106-Fuel pressure relief valve reached maximum allowed opening count
3107-Fuel metering unit is shorted to battery voltage at the low side 3108-Fuel metering unit is shorted to ground at the low side
3112-Fuel rail pressure sensor voltage is higher than expected
3137-Fuel metering unit has an open load error
3141-Fuel pump pressure has exceeded desired pressure limits
3146-Water in fuel detected or water in fuel circuit failure
3170-NH3 sensor signal is not changing
3172-Engine coolant temperature has exceeded the pre-warning threshold
3173-Engine coolant temperature has exceeded the warning threshold...
3176-High pressure pump fuel delivery quantity in over run exceeds a maximum threshold
3177-Engine over speed condition detected
3179-CAN communication failure between vehicle controller and ECU - BC2ECU2 message 3180-CAN communication error between vehicle controller to ECU
3188-Open load error of injector in cylinder 1
3192-Open load error of injector in cylinder 4
3200-Open load error of injector in cylinder 3
3208-Open load error of injector in cylinder 2
3210-Injection bank 1 short circuit failure (all injectors of the same bank can be affected)
3218-Injection bank 2 short circuit failure (all injectors of the same bank can be affected)
3235-Exceeded the number of injections for a given engine speed..
3236-Number of injections is limited by system
3237-Number of desired injections exceeds threshold
3245-ECU internal failure - Query/response communication errors
3252-ECU internal failure - SPI communication error.
3253-ECU internal failure - Voltage ratio in ADC monitoring
3255-ECU internal failure - ADC test ....
3256-ECU internal failure - NTP error in ADC monitoring
3258-Starter relay high side driver circuit short to battery failure
3259-Starter relay high side driver circuit short to ground failure
3260-Starter relay low side driver circuit open failure
3261-Starter relay low side driver circuit short to battery failure
3262-Starter relay low side driver circuit short to ground failure
3265-Fuel injection requested during overrun

3090-Camshaft speed sensor values are not plausible
3091-Camshaft speed sensor pattern is not plausible
3093-Compared camshaft and crankshaft speed sensor values are not plausible 3096-CAN A Bus off failure
3097-CAN B Bus off failure
3102-Fuel rail pressure sensor voltage is lower than expected
3104-Fuel pressure relief valve is open
3283-ECU internal failure - Sensor 5 volt supply 2
3285-ECU internal failure - Sensor 5 volt supply 3
3293-Fuel rail pressure has exceeded maximum positive deviation limits
3301-Fuel rail pressure has exceeded maximum negative deviation limits
3305-Fuel rail pressure has dropped below the minimum limit.
3309-Fuel rail pressure has exceeded maximum limit
3334-CAN communication failure between vehicle controller and ECU controller - TSC1_PE message:
3338-CAN communication failure between vehicle controller and ECU controller - TSC1_VE message
3339-CAN communication failure between vehicle controller and ECU controller - TSC1_VE message
3358-CAN transmit error - EEC1 message (Electronic Engine Control 1 message - Torque, accelerator pedal, engine speed, and other signals)
3361-ECU internal failure - EEPROM write/read error
3368-Torque limitation caused by performance limiter
3369-Torque limitation caused by smoke limitation
3370-Torque limitation due to engine protection
3371-Strong torque limitation from injection system active
3403-Starter relay low side ECU driver circuit over temperature failure
3405-Wastegate pressure modulator control circuit open
3409-Defect fault check for minimum oil pressure from digital sensor
3410-Throttle valve actuator will not open to commanded position (*)
3411-Throttle valve actuator will not close to commanded position (*)
3425-Turbocharger boost pressure is higher than expected
3436-Inducement system is locked due to 3 detections in 40 hours. The system must be reset using the dealer service tool screen "Engine Restart Counter Reset".
3449-ECU internal failure - Calculated engine speed.
3457-Intake manifold temperature sensor voltage is higher than expected
3461-ECU internal failure - Timeout in the shut off path test error
3462-ECU internal failure - Overvoltage monitoring error
3501-ECU internal failure - Software resets in DSM 0
3502-ECU internal failure - Software resets in DSM 1
3503-ECU internal failure - Software resets in DSM
3507-Engine cranked for too long or keyswitch failure
3508-Torque limitation active ....
3517-Ambient temperature sensor voltage is higher than expected
3518-Ambient temperature sensor voltage is lower than expected
3581-Torque limitation is active
3616-Torque limitation caused by turbo charger protection
3623-Downstream NOx sensor lambda signal deviation - NOx sensor possible removal detected. 3652-CAN A Bus off passive failure....
3656-Torque limitation caused by particulate filter
3680-Engine speed limitation via fuel injection cut off is active
3703-The minimum rail pressure value necessary to allow fuel injection has not been reached
3735-Fuel metering unit has an over temperature error
3738-ECU internal failure - ROM error
3739-ECU internal failure - Loss of synchronization to MM from CPU
3740-ECU internal failure - ECU shutdown test failure.
3741-ECU internal failure - Wrong set response time..
3742-ECU internal failure - SPI errors during MOCSOP execution
3743-ECU internal failure - Undervoltage monitoring error 3745-ECU internal failure - WDA is not working correctly
3746-ECU internal failure - Alarm task period error
3747-ECU internal failure - Positive test failed ....
3749-ECU internal failure - Accelerator pedal position sensor
3750-ECU internal failure - Fuel injection energizing time is not plausible 3751-ECU internal failure - Fuel injection energizing phase is not plausible 3752-Fuel injection correction has exceeded a minimum limit ....
3753-ECU internal failure - Injection quality correction ...
3754-ECU internal failure - Rail pressure plausibility
3755-ECU internal failure - Torque request comparison
3756-ECU internal failure - Post injection quality
3757-ECU internal failure - Post injection shut-off failure
3759-ECU internal failure - Torque request due to fuel pressure exceeds maximum torque limit....
3760-ECU internal failure - Torque request due to air control exceeds maximum torque limit
3761-ECU internal failure - Torque request exceeds maximum torque limit...
3764-ECU after run power interruption
3767-ECU internal failure - 'WDA active' reported due to errors in query/response communication
3768-ECU internal failure - 'ABE active' reported due to undervoltage detection
3769-ECU internal failure - 'ABE active' reported due to overvoltage detection
3770-ECU internal failure - 'WDA/ABE active' reported
3773-Turbocharger boost pressure is lower than expected..
3794-Plausibility Check for air pressure at the upstream of intake valve sensor
3795-Plausibility Check for air pressure at the upstream of intake valve sensor
3799-Fuel pressure relief valve is forced open, perform pressure shock
3805-Maximum rail pressure exceeded
3808-High pressure pump fuel delivery quantity at low idle is too high
3810-Rail pressure sensor value is intermittent..
3811-ECU internal failure - Sensor 5 volt supply 1..........